Avlink PG-H1 Uživatelský manuál

0 1PATTERN GENERATOR PG-H1 USER MANUAL V.2011PGH101.00 Copyright and Trademar

9 HDCP: PG-H1 had enabled HDCP function. Enable this function to accept the high video resolution. (You can enable this function by press MENU/Func/S

10  “▲”: Switch the Resolution and Refresh Rate values with up page. (refer to Appendix A: PG-H1 output signal specification chart)  “▼”: Switch t

11 P02 Blinking mode configuration: Press the set indicated key to enter the black and white setting configuration as below (you can set the black a

12 Under the Func/Setup configurations allow you to set the DVI (mode)/RGB (color) and HDCP functions.  MOD: Support DVI/H8/H10/H12 modes, please pr

13 Under the HTPLG Info screen, please press the “” to enter the HTPLG Info configuration screen as below: For the HTPLG Info will show you the

14  “0”: Represent for “Enable”.  “X”: Represent for “Disable”.  “R”: Red component output.  “G”: Green component output.  “B”: Blue compone

15 Chapter 4 Troubleshooting 1. If there is no image when using the PG-H1, please ensure the following matt

16 Appendix A PG-H1 Output signal specification chart: Sync Polarity NO Resolution Refresh Rate (Hz) Pixel

17 251280x1024 60 108 P P 261280x1024 75 135 P P 271280x1024 85 157.5 P P 281360x768 60 85.5 P P 391400x1050 60 RB 101 P N 301400x1050 60 121.7

18 Appendix B Pattern chart: 1. FLAT 2. Blinking 3. BW_GRADUALLY 4. GRID_4x3 5. GRID_16x12 6. COLOR

1 Chapter 1 Introduction... 2 1.1 Package Contents...2 1.2 Resolution.

19 29. BLOCK_1 30. BLOCK_4x3 31. BLOCK_16x12 32. HLINE_1 33. HLINE_2 34. HLINE_3

2 Chapter 1 Introduction PG-H1 is a test pattern generator designed to be a useful tool for the new generat

3 1.2 Resolution  Use for test and calibrate a HDTV monitor.  Use for test and calibrate HDMI image input devices.  Use for test and maintain

4 1.5 Front Panel 1. HDMI Transmission Port: Connect to the attached HDMI 3M cable. 2. LCD Module: 16*2 Character Display. 3. Function Keys: Depend

5 1.6 Side Panel 1.6.1 HDMI Transmission Port Use for HDMI 3M cable connector. 1.6.2 HDMI Type A Connector pin definition Pin # Signal Pin # Sign

6 Chapter 2 Connection 2.1 Preparation Caution Please power off the digital monitor and PG-H1 before you begin the connection.2.1.1 Plugs PG-H1 supp

7 2.2 Connect PG-H1 to Monitor  Connect the attached DC adapter cable from PG-H1 to the power source (out

8 Chapter 3 Operation )1. After pressing the power On/Off key for 2~3 seconds to sound a long “beep”. 2. Only for the valid key of PG-H1 will sound a